Sweep Frequency Response Analyzer for Transformer Test

• Customization: Available
• After-sales Service: Suppor for Lifelong
• Warranty: 1 Year or Extend
• Model NO.: HM5010
• Type: Transformer Tester
• Display: Digital
• Control: Computer Control
• Power Source: AC220V
• Test Range: (-100dB) - (+20dB)
• Frequency Accuracy: <0.01%
• Scan Mode 1: Linear Scanning Distribution
• Scan Mode 2: Segment Frequency Scanning Measurement Distributio
• Frequency Scanning Measurement Range: (0.5kHz) - (1MHz)
• Scanning Frequency Accuracy: 0.01%
• Amplitude Measurement Accuracy: 0.1dB
• Amplitude Measurement Range: (-120dB) to (+20 dB)
• Ignal Input Impedance: 1mΩ
• Ignal Output Impedance: 50Ω
• Nw: 13kgs
• Standard: IEC
• Certificate: ISO, SGS, TUV
• Transport Package: Wooden Box with Foam Inside
• Specification: 31cm *15cm *15cm
• Trademark: HMDQ
• Origin: Hubei, China(Mainland)
• Production Capacity: 500 Set Per Year

Product Description

Sweep Frequency Response Analyzer for transformer test

I. Overview
The Sweep Frequency Response Analyzer is used for power transformer with voltage grade of 66kV and above and other transformers with special purpose. The power transformer is inevitably vulnerable to impulse of various fault short-circuit current or physical collision in the process of operation and transportation and the transformer windings may lose stability under the powerful electro-dynamic force exerted by such short-circuit current, which could result in permanent deformations such as local distortion, swell or dislocation and will severely affect safe operation of the transformer.


II. Main Technical Characteristics

1. Characteristics of transformer windings are measured with frequency sweep method. Deformations of windings such as distortion, swell or displacement of 66kV and above transformer are measured by detecting amplitude-frequency response characteristics of each winding, not requiring lifting of transformer enclosure or disintegration.
2. Quick measuring, measuring of a single winding is within 2 minutes.
3. High frequency accuracy, higher than 0.001%.
4. Digital frequency synthesis, with higher frequency stability.
5. 5000V voltage isolation fully protects safety of the testing computer.
6. Able to load 9 curves at the same time and automatically calculate parameters of each curve and diagnose winding deformations to provide the reference diagnosis conclusion.
7. Analysis software has powerful functions and software and hardware indicators satisfy national standard DL/T911-2016/IEC60076-18.
8. Software management is humanized with high degree of intelligence. You only need to click one key to complete all measurements after setting of parameters.
9. The software interface is concise and vivid, with clear menus of analysis, save, report export, print, etc.

III. Main technical parameters

1. Measuring speed: 1 min- 2 min for single-phase winding
2. Output voltage: Vpp-25V, adjusting automatically in test
3. Output impedance: 50Ω
4. Input impedance: 1MΩ (the response channel is built with 50Ω matching resistance)
5. Frequency sweep scope: 10Hz-2MHz  
6. Frequency accuracy: 0.001%
7. Frequency sweep manner: linear or logarithmic, frequency sweep interval and number of sweep points are freely settable
8. Curve display: amplitude-frequency curve
9. Width of measuring dynamic range: -100dB~20dB
10. Supply voltage: AC100-240V   50/60Hz  (use DC12V Adapater recommend)